$149.99 - $139.99
(as of Jan 10,2020 15:00:56 UTC – Details)
Thermoflow UT10 2.6-Gallons Electric Mini-Tank Water Heater for Under Sinks
◆ Minimize Wait Time for Hot Water
The Thermoflow UT10 is a point-of-use electric mini-tank heater that can stores up to 2.6 Gallons (10L) of water to supply hot water quickly. This heater can supplement a primary water heating source, or be used under a single sink. There’s minimal stand-by loss from this premium mini-tank water heater, which saves water by eliminating the wait for hot water to reach your faucet.
◆ Active Protection Circuit for Safe Installation
If the water heater does not come out with hot water when it’s already connected to the electric supply, then the water heater will cut off the electric supply automatically to prevent the water heater from overheat. This also reduces the risk of damage to the water heaters.
◆ Thermostop function,Low Standy Loss Power Consumption
Selectable temperature range between 45℉ to 167℉, two modes options, energy-saving mode and frost protection mode, suitable for any season.The maximum temperature raise is 167℉(75℃) for 2.6 GPM and the minimum temperature raise is 45℉（7℃). This also reduces the risk of damage to the water heaters.
1. A SAFETY VALVE IS NOT NECESSARY FOR INSTALLATION!
2. DO NOT install a heater in a location where there is a potential for freezing.
3. BEFORE you connect the device to the electrical supply the device must be filled with water.
4. DO NOT remove the heater cover or open the unit without first turning off the power at the breaker panel.
5. Please read the instruction manual carefully before you install or using the water heater!
PACKAGE INCLUDES –
1X 4.0 Gallons mini-tank water heater
2X 1/2″ NPT brass bushings
1X Water relief valve
1X 1/2″ NPT Connector
1X instruction manual
NOTICES: Showerhead, pedestal and water heater hose are NOT INCLUDED!
Inquiry & aftersales service: [email protected]
Hotline:＋1（844）334-4203➤ 2.6 GALLON CAPACITY – 2.6-gallon point-of-use mini-tank fits under your sink to provide hot water right where you need it.The stainless steel tank and heating element designed for efficiency, durability and easy replacement.
➤ THERMOSTOP FUNCTION – Low stand-by loss power consumption. The Thermoflow UT10 with Advanced Thermostop Technology of Germany, when the water heater reaches a high or low set temperature, it’ll stop heating or reheating automatically.
➤ EPS FOAMING TECHNOLOGY – Heating water quickly, fast recovery rate eliminates long waits for hot water at your sink.
➤ SAFETY – Active protection circuit for safe installation. If the water heater does not come out with hot water when it’s already connected to the electric supply, then the water heater will cut off the electric supply automatically to prevent the water heater from overheat.
➤ NOTES – Please verify that this model is the right size for your hot water needs and electrical requirements before purchase & installation. Dimensions: 18H x 12.2W x 11D inches ;Weight: 14 lbs;Water connections :1/2 inch NPT, Electrical requirements: 1.5 kW, 120 volts. Operating pressure: 150PSI.Nominal current: 13A.